Skip to Main navigation Skip to Left navigation Skip to Main content Skip to Footer

University of Minnesota Extension
www.extension.umn.edu
612-624-1222

Extension > Garden > Lawns and turfgrass management > Watering > Auditing irrigation systems

Print Icon Email Icon Share Icon

Auditing home lawn irrigation systems

Sam Bauer

Conducting an inspection of your home watering system is an important practice for maximizing water use.  Audits ensure that water is applied evenly to all areas of the lawn and determine how long a system should run. A basic irrigation audit should be performed every spring as systems are charged up for the growing season.  Below is a step-by-step guide to auditing your home lawn irrigation system. 

Replace broken and leaky sprinklers.

Irrigation auditing procedure

Step 1: System inspection

Run each irrigation zone and look for broken sprinklers, low water pressure and water spray that is distributing water where it is not needed (e.g; on streets). Replace any broken sprinklers, correct water pressure accordingly, and make adjustments so your system is supplying water only where you want it.

Place catch cans in a grid pattern.

Step 2: Performance testing

To begin the performance test, place catch cans on the lawn in an evenly spaced grid pattern throughout an individual irrigation zone.

Cans should be placed 5 to 8 feet apart for small area spray-sprinklers and 10 to 20 feet apart for large area rotor-type sprinklers.

A minimum of 20 cans should be used for each irrigation zone; more cans allow for greater accuracy. Tuna or coffee cans work well for this, or you can purchase cans made specifically for conducting these audits.

Measure the depth of water in each can.

After the catch cans are placed throughout an irrigation zone, run the zone for 30-60 minutes.  A longer run-time will provide more accurate results.

Next, measure and record the depth in inches of water in each can.

Repeat this procedure for each individual zone of your irrigation system. 

Step 3: Uniformity calculations and scheduling zones

Calculating the uniformity and precipitation rates of your watering system will tell you how long to set your watering time and if your lawn is being watered evenly.

Precipitation rate calculations

Once you have calculated the precipitation rate for each zone, you can set the run times. For example, if your goal is to apply 0.5 inches in one irrigation cycle and the precipitation rate is 1.5 inches per hour, you would set the zone for 20 minutes.

To calculate the precipitation rate, average the depth of water in the catch cans after one hour of run time.

For example, if the average depth of our 20 cans was 0.75 inches and we ran the zone for 30 minutes, our precipitation rate would be 1.5 inches per hour.

Uniformity calculations

Calculating uniformity will tell you if your watering system is over-watering or under-watering in certain areas. For uniformity calculations, take the average depth of the lowest 25% of cans (If you used 20 cans this would be the five lowest cans) and divide by the overall average of all cans.

For example, if the average of our five lowest measuring cans is 0.5 inches, divide 0.5 by 0.75 = 0.67 or 67%. Irrigation systems with lower than 60% uniformity should be adjusted for more uniform coverage.

 

For more information:

2017

  • © Regents of the University of Minnesota. All rights reserved.
  • The University of Minnesota is an equal opportunity educator and employer. Privacy